Policies - Settings tab - Patch Settings

NAVIGATION  Policy Management > Policies > Settings tab > Patch Settings checkbox

The Patch Settings category assigns patch settings to a policy.

Pre/Post Procedure

Run procedures either before and/or after Initial Update or Automatic Update. For example, you can run procedures to automate the preparation and setup of newly added machines before or after Initial Update.

  • Run procedure before Initial Update
  • Run procedure after Initial Update
  • Run procedure before Automatic Update
  • Run procedure after Automatic Update

Patch Policy Membership

Assign one or more patch policy names to this policy.

Patch Alert

Check any of these checkboxes to perform their corresponding actions when an alert condition is encountered.

  • Create Alarm
  • Create Ticket
  • Run Script<agentprocedure> on <machineID>
  • Email Recipients - Enter multiple addresses separated by commas.

    NOTE   This field may make use of tokens.

The system can trigger an alert for the following alert conditions for a selected machine ID:

  • New patch is available
  • Patch install fails
  • Agent credential is invalid or missing

    NOTE   An agent credential is not required to install patches unless the machine’s File Source is configured as Pulled from file server using UNC path. If an agent credential is assigned, it will be validated as a local machine credential without regard to the File Source configuration. If this validation fails, the alert will be raised. If the machine’s File Source is configured as Pulled from file server using UNC path, a credential is required. If it is missing, the alert will be raised. If it is not missing, it will be validated as a local machine credential and as a network credential. If either of these validations fails, the alert will be raised.

  • Windows Auto Update changed